ssf

ssf places the shell nodes of a region on an intp surface and gives each a thickness measured between the two surfaces the intp lies between.

Syntax

ssf imin jmin kmin imax jmax kmax surface

The six numbers are a region, a face on a shell partition; surface is the number of a surface of type intp (sd), with or without sd before it.

What it does

As sf, at steps 3, 6 and 9, for the nodes of the region that lie on a shell element: each is moved to the point of the intp surface nearest to it. The intp surface is the first of its two surfaces carried toward the second by the fraction, point by point along the second’s nearest points, and James finds the nearest point of that surface by a search over the first surface that starts from the node’s own projection. When the part ends, every corner at such a node of every shell whose four corners lie in the region takes as its thickness the chord between the two surfaces at the base of the node’s nearest point, so a shell between two surfaces that approach each other thins where they do.

When James applies it

Steps 3, 6 and 9, as sf; the thickness when the part’s steps are done.

Rules James adds

  • The surface must be of type intp (E1405); sf and sfi project onto any surface.
  • A node of the region that lies on no shell element is not moved. A block region is refused (E0807), and an edge, a vertex or a face on a solid partition, which holds no shell element by th’s rule, warns (E1402): its nodes on shells are still moved, and no thickness is set. The thickness is set on every shell whose four corners lie in the region, as for th.
  • The search for the nearest point works in lengths of the surfaces’ own feature size (the smallest radius among them), but its rounding grows with the distance from the origin: roughly a thousand to ten thousand feature sizes out, an edge whose nodes are held to the intp surface stops settling, and James stops with did not settle onto its surfaces in 100 rounds (Messages from the engine). Not every model fails at the same distance. James meets the surfaces where the script puts them, so tr and cycorsy cannot bring such a model nearer: write its surfaces and parts nearer the origin and move the mesh afterwards, outside James, which has no post-mesh move.
  • The thickness is the chord from the base point, on the first surface, of the node’s nearest point on the intp surface to that base’s nearest point on the second surface, measured when the part’s steps are done. Between two concentric spheres it is their radial distance everywhere, to the last digit or two, and the Abaqus deck carries it as one section, since thicknesses within 64 units of the last place of each other are one there; between surfaces that are not parallel it varies from corner to corner, and the Abaqus deck then carries a nodal thickness table.

Diagnostics

  • E1405: the surface is not of type intp.
  • E0800: the surface is not defined.
  • E0807: the region is a block.
  • E1402: the region holds no shell element.

Example

The script tests/corpus/241-ssfi-surface-not-intp/input.tg, which make test runs:

c only an intp surface has the two bounding surfaces the thickness is measured between
sd 1 sp 0 0 0 1
block -1 -3;-1 -3;1 -3;-1 1 -1 1 0 1
ssfi -1 -2;;;1
endpart

Surface 1 is a sphere, so the ssfi is refused. James prints the message in tests/corpus/241-ssfi-surface-not-intp/expected.diag.txt:

input.tg:4:14: error [E1405]: 'ssfi' surface 1 must be of type intp
james: 1 error, 0 warnings

See also

  • ssfi: the same command with an index progression.
  • sd: the intp surface type.

James 0.8.0.

This site uses Just the Docs, a documentation theme for Jekyll.